Workshop on Advanced 3D Modeling and Printing


This 5-hour workshop consists of two sessions. In the first 3-hour session, students will learn to use 3D scanner and Autodesk’s Meshmixer to scan and sculpt a 3D model of themselves. In the second 2-hour session, students will learn to fine-tune and adjust the details of their models, then print out the fine and detail 3D model. Besides, students will have opportunities to learn about the functions of different models of 3D printers. After completing the workshops, you will be awarded a Certificate of Completion and you may also become our EdUHK ambassadors to promote 3D printing and STEAM education.

Application Requirements

In order to make it fair to applicants and for better resources allocation, lower priority will be given to those who did not show up at an enrolled workshop without advance notification;

Higher priority will be given to those who have attended the 39-hour courses on “Introduction to Apps Development and 3D Printing”, “Coding Apps for Mathematics Learning and Teaching”, the 3-hour workshop “Introduction to 3D Printing”; or have basic knowledge about 3D printing.


Students shall complete BOTH Sessons to get a Certificate of Completion.

Students are expected to display their final 3D printing products at LTTC for knowledge transfer and project showcase.

Tutor: LTTC staff
Duration: 5 hours in total (3+2 hours)
Venue: Computer and 3D Printing Room (E-P-12) and
3D Printing Room (E-P-08)(Preview)
Quota: 30 students
Enrollment Link:


Workshop Schedule

Workshop Topic Date Time
Workshop on Advanced 3D Modeling and Printing 11 June 2019 (Tuesday) Session 1: 10:00-13:00
Session 2: 14:00-16:00

Note: More workshops will be open for enrollment. Please stay tune.


Disclaimer: The information on this website is for general reference only and is subject to change at any time without notice.  The course/workshop would be rescheduled or canceled if deemed necessary.




Tags: ,

Comments are closed.